Check out the new USENIX Web site.


FAST '05 Paper    [FAST '05 Technical Program] next up previous
Next: Introduction

WOW: Wise Ordering for Writes - Combining Spatial and
Temporal Locality in Non-Volatile Caches

Binny S. Gill and Dharmendra S. Modha
IBM Almaden Research Center, 650 Harry Road, San Jose, CA 95120
Emails: {binnyg,dmodha}@us.ibm.com

Abstract:

Write caches using fast, non-volatile storage are now widely used in modern storage controllers since they enable hiding latency on writes. Effective algorithms for write cache management are extremely important since (i) in RAID-5, due to read-modify-write and parity updates, each write may cause up to four separate disk seeks while a read miss causes only a single disk seek; and (ii) typically, write cache size is much smaller than the read cache size - a proportion of $ 1:16$ is typical.

A write caching policy must decide: what data to destage. On one hand, to exploit temporal locality, we would like to destage data that is least likely to be re-written soon with the goal of minimizing the total number of destages. This is normally achieved using a caching algorithm such as LRW (least recently written). However, a read cache has a very small uniform cost of replacing any data in the cache, whereas the cost of destaging depends on the state of the disk heads. Hence, on the other hand, to exploit spatial locality, we would like to destage writes so as to minimize the average cost of each destage. This can be achieved by using a disk scheduling algorithm such as CSCAN, that destages data in the ascending order of the logical addresses, at the higher level of the write cache in a storage controller. Observe that LRW and CSCAN focus, respectively, on exploiting either temporal or spatial locality, but not both simultaneously. We propose a new algorithm, namely, Wise Ordering for Writes (WOW), for write cache management that effectively combines and balances temporal and spatial locality.

Our experimental set-up consisted of an IBM xSeries 345 dual processor server running Linux that is driving a (software) RAID-5 or RAID-10 array using a workload akin to Storage Performance Council's widely adopted SPC-1 benchmark. In a cache-sensitive configuration on RAID-5, WOW delivers peak throughput that is 129% higher than CSCAN and 9% higher than LRW. In a cache-insensitive configuration on RAID-5, WOW and CSCAN deliver peak throughput that is 50% higher than LRW. For a random write workload with nearly 100% misses, on RAID-10, with a cache size of 64K, 4KB pages (256MB), WOW and CSCAN deliver peak throughput that is 200% higher than LRW. In summary, WOW has better or comparable peak throughput to the best of CSCAN and LRW across a wide gamut of write cache sizes and workload configurations. In addition, even at lower throughputs, WOW has lower average response times than CSCAN and LRW.




next up previous
Next: Introduction
Binny Gill 2005-10-17
?Need help?


Last changed: 16 Nov. 2005 jel